Production of H2 and Glucaric Acid Using Electrocatalyst Glucose Oxidation by the Ta NiFe LDH Electrode.

The slow anodic oxygen evolution reaction (OER) significantly limits electrocatalytic water splitting for hydrogen production. We proposed the electrocatalyst for glucose oxidation by Ta-doping NiFe LDH nanosheets to simultaneously obtain glucaric acid (GRA) and hydrogen gas as a useful byproduct. Superior glucose oxidation reaction (GOR) activity is demonstrated by the optimized Ta-NiFe LDH, which has a low overpotential of 192 mV, allowing for a small Tafel slope of 70 mV dec-1 and a current density of 50 mA cm-2. The Ta NiFe LDH-oxidized glucose to GRA with a 72.94% yield and 64.3% Faradaic efficiency at 1.45 VRHE. Herein, we report the Ta NiFe LDH/NF electrode for the GOR&hydrogen evolution reaction (HER), which exhibits a cell voltage of 1.62 V to reach a current density of 10 mA cm-2, which is 250 mV lower compared to OER&HER (1.87 V). This study reveals that GOR is an energy-efficient and cost-effective method for producing H2 and valorizing biomass.

Electrocatalytic Reactions for Converting CO2 to Value-Added Products: Recent Progress and Emerging Trends.

Carbon dioxide (CO2) emissions are an important environmental issue that causes greenhouse and climate change effects on the earth. Nowadays, CO2 has various conversion methods to be a potential carbon resource, such as photocatalytic, electrocatalytic, and photo-electrocatalytic. CO2 conversion into value-added products has many advantages, including facile control of the reaction rate by adjusting the applied voltage and minimal environmental pollution. The development of efficient electrocatalysts and improving their viability with appropriate reactor designs is essential for the commercialization of this environmentally friendly method. In addition, microbial electrosynthesis which utilizes an electroactive bio-film electrode as a catalyst can be considered as another option to reduce CO2. This review highlights the methods which can contribute to the increase in efficiency of carbon dioxide reduction (CO2R) processes through electrode structure with the introduction of various electrolytes such as ionic liquid, sulfate, and bicarbonate electrolytes, with the control of pH and with the control of the operating pressure and temperature of the electrolyzer. It also presents the research status, a fundamental understanding of carbon dioxide reduction reaction (CO2RR) mechanisms, the development of electrochemical CO2R technologies, and challenges and opportunities for future research.

Photoelectrochemical Epoxidation of Cyclohexene on an α-Fe2O3 Photoanode Using Water as the Oxygen Source.

This study developed a safe and sustainable route for the epoxidation of cyclohexene using water as the source of oxygen at room temperature and ambient pressure. Here, we optimized the cyclohexene concentration, volume of solvent/water (CH3CN, H2O), time, and potential on the photoelectrochemical (PEC) cyclohexene oxidation reaction of the α-Fe2O3 photoanode. The α-Fe2O3 photoanode epoxidized cyclohexene to cyclohexene oxide with a 72.4 ± 3.6% yield and a 35.2 ± 1.6% Faradaic efficiency of 0.37 V vs Fc/Fc+ (0.8 VAg/AgCl) under 100 mW cm-2. Furthermore, the irradiation of light (PEC) decreased the applied voltage of the electrochemical cell oxidation process by 0.47 V. This work supplies an energy-saving and environment-benign approach for producing value-added chemicals coupled with solar fuel generation. Epoxidation with green solvents via PEC methods has a high potential for different oxidation reactions of value-added and fine chemicals.